![]() ![]() Once the exit delay expires, the system will be fully armed. ![]() The system will recognize that occupants have left the premises. To arm in the Away mode, enter your and exit the premises through a designated Exit/Entry door. If motion is detected in the interior zones, or if one of the perimeter zones is violated, the alarm sequence will begin. NOTE: If you arm the system with a zone bypassed or with a trouble present, your security protection is reduced.Īrming the system in the Away mode will have all interior zones and perimeter zones active. If this message appears, be aware of which zones are bypassed and why. This message will be displayed once the exit delay expires and the system is fully armed. Exit through the door indicated by your installer as the Exit/Entry door. You can restart the exit delay once by pressing the button before the exit delay expires. The panel will provide an exit delay period, also indicated by keypad beeps, for you to exit the premises without causing an alarm. #PC5010 DISPLAY MASTER CODE CODE#Once the correct user code has been entered, the display will be as shown. If this display is showing, the system is in the Ready state and may be fully armed. When this message appears, use the arrow () keys to verify that the system is clear of troubles and that no zones are bypassed unintentionally. #PC5010 DISPLAY MASTER CODE WINDOWS#To secure the system, close all doors and windows and cease all motion in areas covered by motion detectors. When this message appears, one or more zones are not secured. The exit delay time can be changed by your installer. At the end of the exit delay period, the Ready light will turn OFF and the system will be armed. The panel will provide an exit delay period, indicated by keypad beeps, for you to exit the premises without causing an alarm. Exit the premises through the door indicated by your installer as the Exit/Entry door. If the correct access code is entered, the keypad sounder will beep quickly and the Armed light will come ON. If this occurs, press the key and re-enter your. If the access code was entered incorrectly, the keypad buzzer will sound steadily for two seconds. As each digit is entered, the keypad sounder will beep. The system Cannot be armed unless the Ready light is ON indicating that all zones are closed and the system is in the Ready state.Įnter your. If the Ready light is OFF, check to see that all doors and windows are closed and that motion is stopped in areas covered by motion detectors. ![]() If the Ready light is ON, the system is ready for arming. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |